Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Dial-Peer Forwarding

I have 2 fax machines, i want one to forward to the other if the first doesnt pick up.

The two configs i have:

dial-peer voice 2153 voip

destination-pattern 2153

modem passthrough nse codec g711ulaw

voice-class h323 1

session target ipv4:192.168.0.1

codec g711ulaw

fax rate disable

and:

dial-peer voice 7367 voip

destination-pattern 7367

modem passthrough nse codec g711ulaw

voice-class h323 1

session target ipv4:192.168.0.1

codec g711ulaw

fax rate disable

I got them setup in the ATA to ring and send, no problem. But when in configuration mode:

ROUTERNAME(config-dial-peer)#

I cannot just enter (call-forward all noan 7367) under the 2153 dial-peer.

I want to forward to 7367 fax, in case the 2153 fax doesnt pick up. Is there any way i can do this?

Thanks in advance!

  • Video Over IP
1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Dial-Peer Forwarding

I am not sure if I correctly understand your problem but maybe you can solve it by creating 2 dial-peers with the same destination-pattern but with different priorities. Then if the first dial-peer can't handle the call then the 2nd one would be used. In the 2nd dial-peer you then rewrite the destination number with translation-profiles.

dial-peer voice 2153 voip

destination-pattern 2153

modem passthrough nse codec g711ulaw

voice-class h323 1

session target ipv4:192.168.0.1

codec g711ulaw

fax rate disable

preference 1

dial-peer voice 2153 voip

destination-pattern 2153

modem passthrough nse codec g711ulaw

voice-class h323 1

session target ipv4:192.168.0.1

codec g711ulaw

fax rate disable

preference 2

translation-profile outgoing CHANGE_DNIS_TO_7367

1 REPLY
New Member

Re: Dial-Peer Forwarding

I am not sure if I correctly understand your problem but maybe you can solve it by creating 2 dial-peers with the same destination-pattern but with different priorities. Then if the first dial-peer can't handle the call then the 2nd one would be used. In the 2nd dial-peer you then rewrite the destination number with translation-profiles.

dial-peer voice 2153 voip

destination-pattern 2153

modem passthrough nse codec g711ulaw

voice-class h323 1

session target ipv4:192.168.0.1

codec g711ulaw

fax rate disable

preference 1

dial-peer voice 2153 voip

destination-pattern 2153

modem passthrough nse codec g711ulaw

voice-class h323 1

session target ipv4:192.168.0.1

codec g711ulaw

fax rate disable

preference 2

translation-profile outgoing CHANGE_DNIS_TO_7367

201
Views
0
Helpful
1
Replies
This widget could not be displayed.