Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

dial-peer load balancing

hi.

I do below configuration in a (C) router.

A Router and B router was connected

the same PBX(number 5555).

A(1.1.1.1) ----------|

|-(C)

B(2.2.2.2) ----------|

(C) router configuration.

dial-p 1 v voip

destination-p 5555

sesion target ipv4:1.1.1.1

dial-p 2 v voip

destination-p 5555

session target ipv4:2.2.2.2

1.1.1.1(A) and 2.2.2.2(B) is not same router.

when i configure other dial-peer for same number(5555),

I checked call session was balanced to the two router.

for the example,

first call go to the A router.

second call go to the B router.

is this normal symptom?

like acl rule

i want to know dial-peer match rule.

1 REPLY
Hall of Fame Super Gold

Re: dial-peer load balancing

Yes, without a configured preference, calls will go round-robin. You can change that wiht "dial-peer hunt " - type ? to see the possible choices.

Hope this helps, please rate post if it does!

1085
Views
0
Helpful
1
Replies
CreatePlease to create content