You can use two techniques: COR or "steering digits"
On the incoming DP with answer-address, configure either a COR, or translation-profile to add special digits in front of number.
On the outgoing, you create two DP. With cor, each one will have the proper cor setting. With steering digits, you modify destination-pattern to match the special digits, and again a translation-profile to strip the digits.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.