No. That would be one way, but then you would have to buy that box. Try this work around. Down load VLC which is an open source transcoding and media server/multicasting tool available from VLC.org. Run it on a PC or Server. Use your DME 1000 encoder and send the H.264 encoded stream to the server running VLC in a unicast stream. Using VLC Transcode the stream into a MPEG2 TS and send it out of VLC as a multicast. Point your DMPs to the multicast. I have attached a PPT that should be helpful.
The DMP4400 will play a H.264 stream. Since you are unable to get it to work I am assuming you are using DMP4305s for playback.The DMP4305 will not play an MPEG4 H.264 video stream. Check out VLC.org. VLC is open source video transcoding tool. The work around is to Use VLC setup on a laptop or server to transcode the MPEG4 stream into and MPEG2 Transport stream and then set up VLC to multicast the stream to your local LAN. Have each DMP listen for the correct UDP address and port. Hope this works for you.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.