I need to configure Cisco2811 and need to ask PBX-A vendor to add E1 card and configuration to PBX-A. Should I pay attention to CCS ( or CAS ) between PBX-A and Cisco2811 ? Does It has nothing to do with this case ?
controller E1 1/0 framing crc4 clock source line linecode hdb3 ds0-group 1 timeslots 1-8 type e&m-wink-start
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.