I have a situation in a school, where they have an analog phone connected to a POTS line. They want to use this for inbound calls from police, etc. Alternatively, they want to use this line for outbound 911 calls, anywhere in the building. They want it so that if someone dials the outside number, it rings that analog phone endlessly. I have an H3232 2600 terminating in an FXO. I know that I can set the "ring number" on the voice port to "10" but that is just not enough. Wonderring if anyone has any idea on how to ignore the ringing on an FXO port. Thanks
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...