I need to estabish videoconferencing beetween endpoint, which are equipaded with the Cisco IP Thelephony 7960 with the video capacities enabled and Cisco Unified Video Advantage software and Cisco VT Camera II. The version of the Call Manager is the version 5 and the MCU is Cisco IP/VC 3510. I added the MCU 3510 as Conference Bridge in the Call Manager, I created a Media Resource Group List with the 3510 Conference Bridge, the phones 7960 are configured with this Media Resource Group List. But my problems is How configure the MCU 3510 ? and my doubt is, How start a videoconferncing?. For example, if the conference ID is 671234, I need to add a dial peer with this pattern in the call manager and add the MCU as a Gateway H.323 to route those calls to MCU?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...