I have configured 2 locations with 8 ports each of E/M-2VIC cards. Each location can propely call the other but we cannot hear each other? My network provider says the COS is properly configured and ready to go. Phones ring but still cannot hear each other ...
Im im reymark from the philippines my case is a bit similar to firstname.lastname@example.org. I have 2 sites A and B with 4 e/m ports. each is capable accessing external line via tie lines. i can get a line to dial outside but when its already connected the voice is very low. Site A can hear site B but site B cant hear clearly site A. Very Low and Little voice occur. Please help ill post the router config.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...