I am having problems getting two E&M modules to set up a trunk over FR using plar between two pabx's.
It was working well over serial point to point circuits on IOS 11.3 , the client migrated to FR and thus to facilitate the FR I had to up the IOS to 12.3. Since then it doesn't work. I am having problems finding info on debug commands and how to translate their out put. If any one has any suggestions I would be most grateful.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.