EX60 Network Services HTTP Mode via Touch Controller Menu?
Have an EX60 in a remote office that I need to access via its web interface. Don't know how it came to be disabled. Do not have telnet or ssh access. Factory reset is not an option.
What are the exact steps to re-enable the NetworkServices HTTP Mode from the Touch Controller menu?
I just tried walking through the menu with a somewhat savvy worker at this remote office, but she could find nothing under the settings, administrator settings menu that said "network services".
I've also read and reread the the user and administrator guide with no success. The only instruction I can find there is how to enable and disable this setting via the web interface. I won't comment on that... :-)
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...