07-04-2010 04:54 PM - edited 03-17-2019 10:03 PM
Hi all,
Just a quick one, how do I set a Cisco SD IP Camera Indoor Dome 2420 Series back to factory default settings?
I have 4 Cisco cameras setup but for some reason I cannot access the 4th camera.
On the router, I can see arp entry but it is incomplete. All 4 camera is setup in a VLAN which has DHCP enable.
Thanks
Solved! Go to Solution.
07-06-2010 09:04 PM
There is a reset button on the rear of the device. You can perform various resets based on how long you hold the reset button. Check out the info here:
Hailey
Please rate helpful posts!
07-06-2010 09:04 PM
There is a reset button on the rear of the device. You can perform various resets based on how long you hold the reset button. Check out the info here:
Hailey
Please rate helpful posts!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: