cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
283
Views
0
Helpful
1
Replies

FAX with CCM and ATA issue

nomykhan
Level 1
Level 1

Dear Friends

I have a Cisco CallManger 4.2 with 2800 series gateway and ATA's.

E1 is connected with the gateway.Now when i try to send faxes from my fax machine through the ATA some times the fax reaches the destination

correctly and sometimes not .Same is recieving some times it works and sometimes it does not .

I have not applied any special configuration on E1 for FAX calls .Normal config whcih is

dial-peer voice 100 voip

description Forward Inbound Calls to CM (Subsriber)

preference 1

destination-pattern 8...

voice-class codec 1

voice-class h323 1

session target ipv4:10.7.0.13

dtmf-relay h245-alphanumeric

no vad

Do i need to configure anything on the gateway or ccm or ATA to correct this issue?

Please advise.

regards

Nouman Khan

1 Reply 1

Aaron Harrison
VIP Alumni
VIP Alumni

First of I'd check your E1 clocking - if this is out then you will get issues like this.

Do a sh controllers e1, check for slips.

If you have them, set your clocking up like so:

network-clock-participate wic 0

network-clock-select 1 e1 0/0/0

Obviously use numbers applicable to your install.

Regards

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: