we have recently moved buildings and before our move we were running video conferencing across two pri links. We had multilink configured and were allowing a max of 10 links to come up. Everything worked well and the quality was good.
Since we moved, the remote site is the same but our new site has a fractional rate line instead of a pri. We have configured things the same as before and it works fine except the connections drops after 10 minutes. I have posted my config below, but I cannot determime see anything which is forcing the link to drop.
we have not changed the configs on the Polycom Video Conferencing units either, so I don't think it should be anything there. Has anyone come across this problem before ?
I enclose Show Controllers E1 for both routers below. I was doing more testing yesterday and although the video conference session fails. The line is not dropping. I looked at the output of the show ppp multilink and there was still 3 lines up. Despite the fact the video conference session had ended. I looked through the config options on the video conference boxes, but I could not see anything that would cause the session to drop after 11 minutes. It makes no difference which site we initiate the video con session from, it still fails after 11 minutes. I removed the dialer load threshold command as I could see ther load was dropping during the call and though the line was falling because of this, but as I say I don't believe the line is dropping.
E1 1/0 is up.
Applique type is Channelized E1 - balanced
Far End Block Errors Detected
No alarms detected.
alarm-trigger is not set
Framing is CRC4, Line Code is HDB3, Clock Source is Line.
Data in current interval (93 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...