Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

FXO to FXO disconnect problem - Part1

Hi,

I have 2 sites connected through an hdlc leased line. Each site has router 1750 with one VIC - 2FXO.

Once a call is placed both FXO are stuck in the off hook state. So there is no way to make another call unless I shut down and turn on the ViC again.

I read the "famous" fxo disconnect problem file from Cisco but it didn't help.

I need to know:

1) Is this problem a bug on the FXO ports ?

2) Is this problem from the analog PBX side ?

3) How to solve this problem?

Thanks

  • Video Over IP
4 REPLIES
New Member

Re: FXO to FXO disconnect problem - Part1

Check your exact IOS version against bug toolkit on the TAC page to see if there is a fixed version of code available to you. Cisco should be engaged if you can't find anything there.

New Member

Re: FXO to FXO disconnect problem - Part1

Hi,

you can use FXS cards......you don't have any problem......

Problem is in disconnect reason....FXO card no detect disconnect tone from PBX....

Czech firm 2N sell special "disconnect module" fot these card......

(I'm sorry for my English...:o)

New Member

Re: FXO to FXO disconnect problem - Part1

I think Jan is correct. How does the FXO know to disconnect? The FXS is not going to tell it, so I think you need to figure out some sort of disconnect supervision.

New Member

FXO to FXO disconnect problem - Part1

Hi a.helou 

Did You found the solution for this problem ?

Thx,

Susanto

413
Views
0
Helpful
4
Replies