Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

FXS Ports & Pickup Groups

Is there a way to make an analog phone connected to an FXS port a part of a call pickup group that contains both analog phones & IP phones? I setup a lab and used MGCP to add the gateway and I was able to add the DN associated with the FXS port to a call pickup group. However, I am unable to figure out how to answer the call from the analog phone when another IP phone in the call pickup group is ringing.

Thanks in advance

3 REPLIES
New Member

Re: FXS Ports & Pickup Groups

Looks like I might have found the answer. According to Cisco's website, this can be done with the following restrictions:

- CCM 4.2 (or higher I am assuming)

- VG or ISR using SCCP as the signaling protocol

- Enabling auto answer

I am getting the upgrade CD's to test this in out lab. I will try to post another reply with more information as time permits. Here is the link if anybody is interested:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124newft/124t/124t2/ht1vg224.htm

Super Bronze

Re: FXS Ports & Pickup Groups

Hi

You are going down the right track with this.

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1dde5372/0#selected_message

See this other post I made (for a different purpose, but the principal is the same - it just opens up features available to IP phones for FXS ports by registering them using SCCP).

Regards

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
New Member

Re: FXS Ports & Pickup Groups

Thanks Aaron.

Now what I am trying to determine is support in 5.X. In the SCCP document, it shows 4.2, but I have not found much information as of yet. I am assuming that it is supported, but I am more curious about the # of DLU's required for each SCCP endpoint.

370
Views
5
Helpful
3
Replies