Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 
New Member

gatekeeper config

Hi all

I want to send a call to a Gateway which is not registered in my gatekeeper(GK-1).

I found a note in this forum about alias static and tried it but I had no successful step.

I set my gatekeeper as follows :

zone local gk-1

alias static 1720 gkid gk-1 gateway voip ras 1719

gw-type-prefix 2121* gw ipaddr 1720

but the call is rejected

Does anybody have any idea what's wrong?



#debug gatekeeper main 10

5d23h: gk_dns_locate_gk(): No Name servers

5d23h: rassrv_get_addrinfo(212101133452253): Matched tech-prefix 2121

5d23h: rassrv_get_addrinfo(212101133452253): unresolved zone prefix

5d23h: gk_rassrv_sep_arq(): rassrv_get_addrinfo() failed (return code = 0x103)


#show dial-peer voice 21210 voip





Successful Calls = 0, Failed Calls = 17, Incomplete Calls = 0

Accepted Calls = 0, Refused Calls = 0,

Last Disconnect Cause is "15 ",

Last Disconnect Text is "call rejected.",

#sh gatekeeper endpoints



CallSignalAddr Port RASSignalAddr Port Zone Name Type F

--------------- ----- --------------- ----- --------- ---- -- 1720 53350 gk-1 VOIP-GW

H323-ID: gw-1 1720 1719 gk-1 VOIP-GW S

Total number of active registrations = 2

LRQ suspension point failed

1w5d: rassrv_get_addrinfo(212101133452253): Tech-prefix match failed.

1w5d: rassrv_get_addrinfo(212101133452253): Matched zone prefix 2121

1w5d: rassrv_put_remote_zones_from_zone_list() zone kishictgk

1w5d: GK: QUEUE_EVENT (minor 0) wakeup

1w5d: gk_rassrv_sep_arq(): LRQ suspension point failed (return code = 0x4009)

1w5d: GK: QUEUE_EVENT (minor 0) wakeup

1w5d: gk_rassrv: ras cache hit req-type=3, seqnum = 43827,remaddr =


Re: gatekeeper config

Your configuration seems to have no problem. Instead of the Prefix 2121* use the full e164 address and try to send a call to the GW. This should work fine. If this is not working there is some other config issue in the GW and GK.

Then later you change it to the Prefix 2121* to isolate the issue you are facing now.

New Member

Re: gatekeeper config

It's working

Thanks for your Note.

CreatePlease to create content