I'm going to be testing gatekeeper peering with a NexTone and need any references or advice on things to look out for. I've done configurations where the NexTone registers to the Cisco gatekeeper and appears as a gateway, but I've never done the straight peering. Any advice or references for doing this would be greatly appreciated!
Here is the config on my 2600 gatekeeper (12.2.11T2 IOS):
zone remote NEXTONE nextone.com 10.10.10.10
zone prefix NEXTONE *
Provided my IPs are in the NexTone, this should work. Right?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.