We have four sites connected using a ATM backbone with varying amounts of bandwidth to each site. We are currently trying to install a IP video conferencing system using 2600 routers as a gatekeeper/proxy. Is there a way to vary the bandwidth limit on a per site basis instead of using the bandwidth remote command which is a total of all the bandwidth in use?
Are you using multiple gatekeepers? If so, if you configure the bandwidth for each gatekeeper's local zones with the bandwidth command, then you have accomplished your goal of limiting bandwidth based on site. You will not need to configure the bandwidth for a remote zone as it will be done locally on that gatekeeper
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...