I have a customer where whenever the user tried to dial international number e.g. 9001862028377777, the call will get translated at CCM to 0.28377777, which in turn will be passed to the relevant country with Least Cost Routing. 28377777 is the local number for that country, while 0 is outside line.
However, I have checked everything and everytime the user tried to dial 9001862028377777, I can see on the phone display, it tried to dial 028377777, but all the user gets is fast busy tone.
I have attached the debug from CCM. Would appreciated anyone help on this.
Apologies for the delayed response. I presumed your translation pointed at Route List which in turn points at a route group which points at a gateway. Do you have a gateway CCM trace that corresponds with the phone trace.
The fact that the phone trace is reporting call proceeding indicates that the route pattern and translation pattern are good.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...