Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

gk/ipipgw to gk/ipipgw

In the following setup:

vct - gk/ipipgw - fw - internet - fw - gk/ipipgw - vct

2 vct's are registered on a gatekeeper with integrated ipipgw (cube) on 2 different locations. When setting up a session from vct1 to vct2 the call is terminated on the incoming call leg with a normal call clear.

attached the config on the receiving gk/ipipgw and the outcome of: sh gatek call.

The config of GK1 is similar.

Any ideas why the call isn't passed on two the outgoing call-leg?

2 REPLIES

Re: gk/ipipgw to gk/ipipgw

as i can see there is firewall in the path

have enabled the h323 signaling thorugh these firewalls and have enabled h323,h225 inspection ??

New Member

Re: gk/ipipgw to gk/ipipgw

Thanks for your suggestion. There is a h323 enabled firewall between the 2 BE's passing h323, h225. And I can actually see the call comming in on the 1st call leg of the 2nd BE but it terminates there.

167
Views
0
Helpful
2
Replies