Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

h323 GW to UCM call setup question

I was experimenting h323 gw to UCM 7.1.2 call setup today and found something that I couldn't understand.

let's say that there are 3 UCM servers and 1 CCM group configured with only CCM 1 & 2 servers. 1 IP Phone (7965) is registered to CCM group which is registed to CCM 2 server.

H.323 gateway is configured and there is only one voip dial-peer is configured to CCM 3.

When an inbound call comes to h.323 gw, it sends call to CCM 3 and call gets failed.

I then created another voip dial-peer to CCM 2 server. the previous dial-peer (to CCM3) is set to preference 1 and 2nd voip dial peer to CCM2 is set to preference 2.

When call gets to the gw and it sends to the voip dial-peer to CCM3 and it now failover to the 2nd dial-peer to CCM2 and the IP Phone is rigning and call gets connected.

It seems like CCM3 didn't know how to set up the call to IP Phone when the phone is not registered to CCM3

Is this a bug? I don't think this should be happenning.

1 REPLY

Re: h323 GW to UCM call setup question

Hi,

You'll find your answer here:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/7x/trunks.html#wp1044864

Hope it helps, if it does please rate.

Best regards,

- Adrián.

141
Views
0
Helpful
1
Replies