we connect a CCM enviromment via 2801 E1 QSIG with a Hicom. In the IP World we have Phone Numbers 30-39 and 1130-39. From the HICOM world it is not possible to call 1130-39. I configure the D channel for overlap receiving and the CCM service parameter overlap receiving is set to true.
I check the dial plan wit the DNA and it ist possible to reach the 1130 via the QSIG Gateway 2801.
I dont now where is the problem. The Hicom people sayd that is all fine on his side.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...