Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

how can as5400 be used to to terminate voice traffic through ip to ip

i have a question we have as54008e1 with

two fastethernet.i want to terminate voice traffic of

three service providers to germany who will send me

voice trafic through ip.i am also connected to germany

through ip via fa using leased internet connection of

2mb.

my ques is can we use as5400 for this if yes how will

we configure dial peer so service provider at one end

can send trafic to germany through our as5400.

kindly advice.

2 REPLIES
Cisco Employee

Re: how can as5400 be used to to terminate voice traffic through

Hi,

Basically, you want to configure the as5400 as the orginating gateway

(terminating voice from the E1 controller and sending it voip across to Germany). Here is an url which have basic configuration of VoIP:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_serv/as5350/sw_conf/53swcg/54voice.htm

For more information on VoIP and dial-peer and other general stuff,

http://www.cisco.com/warp/public/788/voip/voip.shtml

Thanks,

Chinh

New Member

Re: how can as5400 be used to to terminate voice traffic through

HI CHINH,

Thanks for your help,

can you kindly tell me what is the actual name of this type of configuration when you terminate calls on AS,s e1 making it network side and then send calls back into AS from another e1 for termination.

thanks again

sara

140
Views
0
Helpful
2
Replies