How to verify the routes from router when Polycom device Initiates traffic
Could anyone please assist me in finding out the routes when Polycom device initiated traffic towards the BCS global.
1) polycom equipemnt is connected to the Internal Lan of the customer and its traversing through Router,
I checked though Ip accounting when the user initiates the traffic. (polycom device ip is x.x.x.10 and BCS global network is aa.aa.aa.0). When i checked IP accounting i found the destination ip is x.x.x.10 and source ip is aa.aa.aa.205 when user initiates traffic from Polycom device.
2) I also found the static route in router for BCS global network (aa.aa.aa.0) but when I tried to trace route to IP address (aa.aa.aa.205) the output shows:
1. * * *
2. * * *
10) * * *
Could anyone please assist me is there any other any other way to find out the routes.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...