How would I configure Q0S for voice packets on a 4003 and 5505 switch?
Our PBX is connected to the switch along with some NT servers. The 4003 then connects to a 5505 and the 5505 connects to a 7206. I want to prioritize the voice IP packets on the uplinks between the 4003 and 5505, and 5505 to 7206.
I understand using LLQ on the router, but don't have a clue as to how to do this in a switch.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.