I have a frame-relay network and I have an application that I want priority over the rest traffic. This application run over telnet protocol. I need that while this application is running it has more bandwidth that the rest of the traffic, and when is not running, the resrved bw will be 0. Which QoS Mechanism can I use? Thank you. Regards.
Re: I want priority a voice application over the rest
You could use the priority command to accomplish this. The priority command can either be configured in Kbps or as a percentage of link bandwidth. You will probably want to match traffic on more that the port since doing so would prioritize all telnet traffic. You could also match based on an ACL. See the partial configuration below for an example.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...