Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Interpreter output debug signal in E&M

*Jan 17 20:56:09.871: htsp_timer_stop3

*Jan 17 20:56:09.875: htsp_process_event: [0/2/0, EM_WAIT_FOR_ANSWER, E_HTSP_RELEASE_REQ]em_wait_answer_release

*Jan 17 20:56:09.875: em_stop_timers

*Jan 17 20:56:09.875: htsp_timer_stop

*Jan 17 20:56:09.875: htsp_timer_stop2 em_onhook (0)

*Jan 17 20:56:09.875: [0/2/0] set signal state = 0x0 timestamp = 0

*Jan 17 20:56:09.875: em_start_timer: 400 ms

*Jan 17 20:56:09.875: htsp_timer - 400 msec

*Jan 17 20:56:10.275: htsp_process_event: [0/2/0, EM_GUARD_ALL, E_HTSP_EVENT_TIMER]em_guard_all_timer

*Jan 17 20:56:10.275: em_stop_timers

*Jan 17 20:56:10.275: htsp_timer_stop

*Jan 17 20:56:10.275: em_start_timer: 3000 ms

*Jan 17 20:56:10.275: htsp_timer - 3000 msec

*Jan 17 20:56:10.275: htsp_process_event: [0/2/0, EM_PARK, E_DSP_SIG_0000]em_park_onhook

*Jan 17 20:56:10.275: htsp_timer_stop

*Jan 17 20:56:10.275: htsp_timer_stop2 htsp_report_onhook_sig

1 REPLY
Cisco Employee

Re: Interpreter output debug signal in E&M

the voice port 0/2/0 waited for an answer signal from the PBX. Since this is the same debug output related to the call drop after 3 minutes that was on the IPtel forum, it means you need to add 'auto-cut-through' under the voiceport, or get the PBX techs to programme their PBX properly to provide answer supervision when the PBX extension is picked up.

411
Views
0
Helpful
1
Replies