Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IPVC 3511 E conenctivity problems

Hello,

My customer purchased the 3511 E MCU, so far i can't find any documentation that explains what the two network cards are for, or which one i'm supposed to use. Also when i configured the network settings on MCU, i can't ping the NIC and the LED's are lit green (not blinking), this happened on both NICs. I would appreciate any help.

1 REPLY
Silver

Re: IPVC 3511 E conenctivity problems

The 3511 MCU-E contain a separate MCU and an EMP within a single chassis. One NIC is for the MCU and the other for the EMP; both need to be connected to the network. There are two console ports to facilitate this. The EMP needs to register with the MCU to provide advanced multipoint functionality such as continuous presence.

There is some information regarding the physical ports and the setting of IP addresses at:

http://www.cisco.com/univercd/cc/td/doc/product/ipvc/emp/rel_1/chap1.htm#1030681

http://www.cisco.com/univercd/cc/td/doc/product/ipvc/emp/rel_1/chap2.htm#1029170

I'd always suggest hardwiring both ends of the links to 100/full to avoid any duplex ambiguities.

115
Views
0
Helpful
1
Replies