Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

IPVC Conference password

I am using Netmeeting as the H.323 endpoint, Cisco IPVC MCU, and a 3745 configured as the gatekeeper. I set up a password "1234" in the MCU Conference Manager. When Netmeeting calls I am prompted for the password followed by the #. Does anyone know how to input this on a keyboard? It works fine without a password. There is a place to allow for delimiters but I think only the MCU recognizes them not the 3745 gatekeeper.

1 REPLY
Silver

Re: IPVC Conference password

check the below link for IP/VC which will help you in troubleshooting the problem

http://www.cisco.com/univercd/cc/td/doc/product/ipvc/ipvc3540/mcu_mod/rev_2/chap6.htm

128
Views
0
Helpful
1
Replies
CreatePlease to create content