Two Cisco 2911 w/ IOS 15.1(2a)T. Each router is connected to the PSTN via one E1 connection. Both E1 are from the same provider and use the same number range. This means for incoming ISDN calls, I cannot predict and/or control where the call arrives - it's either router one or router two.
Is it possible and supported to run H.320 with ISO/IEC-13871 bonding in this scenario?
My concern is that some of the secondary B-channels might be received be the "other" 2911..
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...