05-26-2006 09:07 AM - edited 03-17-2019 08:42 PM
Hi,
I have an cisco router 3825 (IOS 12.3(11)T8) with a isdn E1 connected to PSTN and i want connect i have a VIC2-2BRI NT/TE
to a video conference system of PictureTel.
My configs in BRI are:
interface BRI0/2/0
no ip address
isdn switch-type basic-net3
isdn protocol-emulate network
isdn tei-negotiation first-call
isdn layer1-emulate network
isdn incoming-voice voice
isdn send-alerting
isdn skipsend-idverify
line-power
!
interface BRI0/2/1
no ip address
isdn switch-type basic-net3
isdn protocol-emulate network
isdn tei-negotiation first-call
isdn layer1-emulate network
isdn incoming-voice voice
isdn send-alerting
isdn skipsend-idverify
line-power
If connect an isdn phone i can place and receive calls, but i can't do a videoconference.
Regarding channel bonding do i have to do any configuration on router? or what kind of configuration for videoconference router need?
Best Regards,
MC
05-26-2006 11:53 AM
This link might help.
http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00804794c6.shtml
Regards,
Anup
07-07-2006 12:41 AM
hi all
is your configuration working now ?
is it possible to send me the configuration, because i have the same construction with Videokonferenz & hairpinning
07-10-2006 04:10 PM
07-10-2006 08:37 PM
hi
No my system can not run at the moment because our pstn connection was not installed from the provider.
hopefully i can test our system till the end of the week.
P.S. i could also be later because the project is in China and here you go 2 steps further and then 1 step back.....:-)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide