Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Isdn bri configuration for videoconference

Hi,

I have an cisco router 3825 (IOS 12.3(11)T8) with a isdn E1 connected to PSTN and i want connect i have a VIC2-2BRI NT/TE

to a video conference system of PictureTel.

My configs in BRI are:

interface BRI0/2/0

no ip address

isdn switch-type basic-net3

isdn protocol-emulate network

isdn tei-negotiation first-call

isdn layer1-emulate network

isdn incoming-voice voice

isdn send-alerting

isdn skipsend-idverify

line-power

!

interface BRI0/2/1

no ip address

isdn switch-type basic-net3

isdn protocol-emulate network

isdn tei-negotiation first-call

isdn layer1-emulate network

isdn incoming-voice voice

isdn send-alerting

isdn skipsend-idverify

line-power

If connect an isdn phone i can place and receive calls, but i can't do a videoconference.

Regarding channel bonding do i have to do any configuration on router? or what kind of configuration for videoconference router need?

Best Regards,

MC

4 REPLIES
Silver

Re: Isdn bri configuration for videoconference

New Member

Re: Isdn bri configuration for videoconference

hi all

is your configuration working now ?

is it possible to send me the configuration, because i have the same construction with Videokonferenz & hairpinning

New Member

Re: Isdn bri configuration for videoconference

Hi,

It's not working yet!

Do you have this working?

In attach i post config with some config ommited.

If you have any suggestions i aprecciate

thanks

Best Regards

MC

New Member

Re: Isdn bri configuration for videoconference

hi

No my system can not run at the moment because our pstn connection was not installed from the provider.

hopefully i can test our system till the end of the week.

P.S. i could also be later because the project is in China and here you go 2 steps further and then 1 step back.....:-)

232
Views
0
Helpful
4
Replies
CreatePlease login to create content