Hi,
I try to connect a ISDN Video Endpoint with a BRI.
My router use MGCP and is connected to ISDN network by an ISDN PRI.
I think I mustn't use isdn bind-l3 service on BRI and create dial-peer.
A route pattern on CCM use a routelist with BRI intefaces.
I use a BRI crossover cable.
My config is :
network-clock-participate wic 0
network-clock-participate wic 1
network-clock-select 1 E1 0/0/0
...
interface Serial0/0/0:15
no ip address
encapsulation hdlc
isdn switch-type primary-net5
isdn incoming-voice voice
isdn bind-l3 ccm-manager
...
interface BRI0/1/0
no ip address
isdn switch-type basic-net3
isdn protocol-emulate network
isdn tei-negotiation first-call
isdn layer1-emulate network
isdn incoming-voice voice
isdn skipsend-idverify
line-power
...
voice-port 0/0/0:15
cptone FR
...
voice-port 0/1/0
description - corresponds to int BRI 0/1/0
compand-type a-law
...
dial-peer voice 2 pots
description - enable DID on BRI voice port 0/1/0
incoming called-number .
direct-inward-dial
port 0/1/0
dial-peer voice 11 pots
description - outwards call to BRI voice port 0/1/0
destination-pattern 0T
port 0/1/0
forward-digits all
I have layer 1 active but layer 2 not actived.
If I add isdn static-tei 0 on BRI interface, layer 2 is TEI_ASSIGNED.
Does anyone know what is wrong?
Thanks.