Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ISR 2811 with VIC2-2FXS

hi,

We have deployed cisco 2811 router in our network and had installed vic2-2fxs card in one of the HWIC slot.We need to configure fxs card for voip to make a call to branch office and have the following ios c2800nm-ipvoicek9-mz.124-17.bin .The problem we are facing is the router detect vic card under show version command but when show running-config command been given it doesn't display voice-port information to configure the same.We have attached the show tech-support o/p.any suggestion welcomed.

2 REPLIES
Hall of Fame Super Red

Re: ISR 2811 with VIC2-2FXS

Hi Bhavesh,

It Looks like you do not have any DSP resources.You will need something like a PVDM2-8 card on the motherboard to provide DSP resources to the FXS card. Without DSP resources you cannot configure the FXS :)

Hope this helps!

Rob

Re: ISR 2811 with VIC2-2FXS

You don't have any DSPs. This will prevent the card from coming up.

Check this link out, get some PVDMs:

http://www.cisco.com/cgi-bin/Support/DSP/cisco_prodsel.pl

221
Views
0
Helpful
2
Replies