I have Cisco CM 4.1 and MCU with gatekeeper configured. In CCM I have hunt lists, pilot number configured as well. When I start new meeting in MCU GUI and point it out to a phone number included in hunt list it can not dial it. However, if I point it to the phone not included in hunt list/group, it dials it OK.
Any idea why it can't dial any individual phone numbers on hunt list/group?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...