Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MCU/EMP start setup over telnet

once i have found a vxworks command to start the setup remotely, but i lost it.

does anyone know it? it is good start the setup remotely to change e.g. password or IP address for EMP

2 REPLIES
New Member

Re: MCU/EMP start setup over telnet

Hello there, the command you are seeking is modifyTargetDevice and note it is case sensitive. From here you have access to the menu as if you had a console connection.

All the best Roger.

New Member

Re: MCU/EMP start setup over telnet

hi,

thanks a lot, that is what i was looking for.

best

aleksander

207
Views
4
Helpful
2
Replies
CreatePlease to create content