Hello I think you rather mean how do you integrate the Polycom VSX7000 with the Cisco MCU. Well first you would register your VSX with your gatekeeper as an H.323 endpoint and assuming the Cisco MCU is already in and working then just use the VSX as another endpoint and away you go.
If the Cisco MCU is not part of your existing system then see this link
Hello, if you register the MCU as SCCP and a conference resource then only SCCP points could initiate a conference as far as I am aware. If could be a meet me conference and a SCCP could start the confernce then the H.323 could join. You should check out the SRND for the version of CCM you wish to use.
Well, I've checked the docs but they always use a GK.
What made me think in this direction is that when you configure a H.323 endpoint you have the option to select a MGRL so if you have a MCU as conference resource the H.323 endpoint should use it. Even though the MCU is configured as SCCP device it should work with the Polycom since the CUCM is the one that speaks both protocols and does the negotiation between them. An example of this is how IP phones that speak only SCCP get calls from H.323 gateways - CUCM is the intermediate point that does the magic :). Of course these are all assumptions and should be tested...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...