Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Meeeting Place Express and Tandberg Video Conferencing

I have been tasked with intergrating an existing Tandberg 880 and Tandberg 880 MXP with Meeting Place Express 2.x. I am unable to get video from or to the Tandberg cameras when participating in a Meeting Place Express meeting. If anyone knows what I am doing wrong please let me know. I have the 2 cameras set up as H.323 devices in CCM.

3 REPLIES
New Member

Re: Meeeting Place Express and Tandberg Video Conferencing

Dial the endpoint using it's IP. Or, if you have a Gatekeeper and Gateway, than you may understand that an alias E.164 may be needed. If so dial the unit by it's alias, which is usually the last 4 digits of it's ISDN#.

If the above is done and still issue's than a dialing digit may need to be used, for an example: We use 8 for tele calls and 9 for video calls. This is in the H323 Services in the Gateway configuration.

New Member

Re: Meeeting Place Express and Tandberg Video Conferencing

I can only get the 2 devices to call each other via IP address. I do not have a gatekeeper configured. Both sites have a gateway but I am at a loss on how to set this up since I cannot get the device to call anything using DN's. I can call to both devices using their DN's for an audio call but outbound initiated by the devices do not work.

New Member

Re: Meeeting Place Express and Tandberg Video Conferencing

You may also want to check the codec settings and make sure all of them are enabled (H.264, to H.261). Sometimes you may have to disable all but H.261 to verify if that is your issue....

300
Views
0
Helpful
3
Replies