Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

MGCP RouteList failover won't work with down T1 circuit

Today, I observe this situation which prove Cisco MGCP Callmanager route list won't failover to 2nd route group when the 1st route group's T1 circuit is down.

Ie, RoutePattern 9.@ -> RouteList: RL_siteA -> Two RouteGroup: VGW1_T1 and VGW2_T2 which in turn point to the different T1 circuit in different vgw.

When VGW1_T1 circuit status get error 'TEI_Assigned' other than 'Multi_Frame_estabished', Callmanager still show this T1 circuit regsitered and never use 2nd circuit which is VGW2_T2.

So users cannot place outbound calls due to this failed vgw1-T1 circuit even though vgw2-T2 is up.

Is it callmanager limitation?

Anyone know the workaround without manual task to remove and/or re-order route group inside the route list.

My ccm is: 4.1.3

mgcp ver: 0.1

3 REPLIES
New Member

Re: MGCP RouteList failover won't work with down T1 circuit

Addon here:

If vgw1 router is completed down, then 2nd route group will be used.

Hope anyone have such observation and find out any workaround and/or contact Cisco TAC for assistance.

New Member

Re: MGCP RouteList failover won't work with down T1 circuit

What worked for me was the service parameter "Stop Routing on Unassigned Number Flag".

New Member

Re: MGCP RouteList failover won't work with down T1 circuit

Appreciate for the share.

Acutally, the issue was due to hang up local T1 port (no PSTN vendor issue) - after reset it came backup. So I didn't have chance to test out this parameter.

150
Views
0
Helpful
3
Replies
CreatePlease to create content