Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

New thread to old question

Have call manager express. Need to find a way to ring both an analog phone and voip phone at the same time.

I have setup a dial peer as follows:

dial-peer voice 7399 voip

destination-pattern 7399

modem passthrough nse codec g711ulaw

voice-class h323 1

session target ipv4:192.168.1.1

codec g711ulaw

fax rate disable

Ephone-dn setup like:

ephone-dn 1 dual-line

number 7399

ephone 1

button 1:1

Any ideas how to make these both ring at the same time? Only the ip phone rings.

5 REPLIES
Hall of Fame Super Gold

Re: New thread to old question

where is the analog phone ? Do you have an FXS port in the router, or ata ?

New Member

Re: New thread to old question

Using an ATA

Hall of Fame Super Gold

Re: New thread to old question

Upgrade ATA to latest SCCP code. Configure as ephone and assign the same DN "button".

If you do not have CCO download access for ATA image, get a maintenance contract or email me.

New Member

Re: New thread to old question

Im pretty sure i have the latest ATA image. But how do i configure it as an ephone?

Hall of Fame Super Gold

Re: New thread to old question

Which image do you have? You need a SCCP image, not H.323.

Then configure just like two ephones, each with mac, type ATA and button.

149
Views
0
Helpful
5
Replies
CreatePlease to create content