NM-HDV2-1T1/E1 query

[wmmak]

Hi all,

Is the built-in T1/E1 port of NM-HDV2-1T1/E1 supporting voice and data?

Thanks

mak

[spremkumar · Accepted solution]

Hi

As per this data sheet it does supports the following features..

Channel-groups can be defined on any T1/E1 controller to generate serial interfaces for HDLC, Frame-Relay, and PPP connectivity.

Thirty-two High-Level Data Link Control (HDLC) controllers available to support data connectivity through channel-group configuration (a PRI group also counts as one data connection).

Maximum aggregate throughput of all channel-groups defined on the NM is 2 Mbps.

Ability to participate in chassis Time Division Multiplexing (TDM) backplane clocking, if applicable.

Dual independent clock domains for onboard T1/E1 controllers, provided at least one controller is used only for data connectivity.

Online Insertion and Removal (OIR) is supported, but only on the Cisco 3745 and 3845 platforms.

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a008039c333.shtml#dmf

regds

[safe]

Dear Prem,

I have one query reg E1 & T1 mapping .

As in India E1 technology works while in US T1 works .If i have to take 2 Mbps IPLC from India to US then how this mapping will be done.If u have any case studies or documentation for this pls give links.

TIA

Regards

SAM