Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NM-HDV2-1T1/E1 query

Hi all,

Is the built-in T1/E1 port of NM-HDV2-1T1/E1 supporting voice and data?

Thanks

mak

1 ACCEPTED SOLUTION

Accepted Solutions

Re: NM-HDV2-1T1/E1 query

Hi

As per this data sheet it does supports the following features..

Channel-groups can be defined on any T1/E1 controller to generate serial interfaces for HDLC, Frame-Relay, and PPP connectivity.

Thirty-two High-Level Data Link Control (HDLC) controllers available to support data connectivity through channel-group configuration (a PRI group also counts as one data connection).

Maximum aggregate throughput of all channel-groups defined on the NM is 2 Mbps.

Ability to participate in chassis Time Division Multiplexing (TDM) backplane clocking, if applicable.

Dual independent clock domains for onboard T1/E1 controllers, provided at least one controller is used only for data connectivity.

Online Insertion and Removal (OIR) is supported, but only on the Cisco 3745 and 3845 platforms.

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a008039c333.shtml#dmf

regds

2 REPLIES

Re: NM-HDV2-1T1/E1 query

Hi

As per this data sheet it does supports the following features..

Channel-groups can be defined on any T1/E1 controller to generate serial interfaces for HDLC, Frame-Relay, and PPP connectivity.

Thirty-two High-Level Data Link Control (HDLC) controllers available to support data connectivity through channel-group configuration (a PRI group also counts as one data connection).

Maximum aggregate throughput of all channel-groups defined on the NM is 2 Mbps.

Ability to participate in chassis Time Division Multiplexing (TDM) backplane clocking, if applicable.

Dual independent clock domains for onboard T1/E1 controllers, provided at least one controller is used only for data connectivity.

Online Insertion and Removal (OIR) is supported, but only on the Cisco 3745 and 3845 platforms.

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a008039c333.shtml#dmf

regds

New Member

Re: NM-HDV2-1T1/E1 query

Dear Prem,

I have one query reg E1 & T1 mapping .

As in India E1 technology works while in US T1 works .If i have to take 2 Mbps IPLC from India to US then how this mapping will be done.If u have any case studies or documentation for this pls give links.

TIA

Regards

SAM

138
Views
0
Helpful
2
Replies
CreatePlease login to create content