cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
344
Views
0
Helpful
1
Replies

No Audio between phones

ysloh
Level 1
Level 1

Hi

We have the below setup

E1 QSIG

Analog Phone --> PABX --> Voice Gateway --> CUCM --> IP Phones

Are are able to place calls between the PABX phones and the IP phones. However, we do not get any audio after the call is picked up.

Have tried to place a call between the PABX phones routing thru the voice gateway. Also faced the same issue.

Would like to know if anyone has faced similar problem, or have any advice on area to look into.

1 Reply 1

Brandon Buffin
VIP Alumni
VIP Alumni

Sounds like a routing issue. Make sure that there is IP connectivity between phones/gateways, etc. Check the default gateway assigned to these devices.

Brandon

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: