Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

no ring-back

Hello,

I have place a call from a ipphone(callmanager) to pbx, (ipphone-callmanager) ----> Cisco Gateway(1760(BRI NT))----> PBX(TE), with no ring-back , from the documents I read with tone ring-back alert-no-PT in the pots I could resolve the problem, but from the debug isdn q931 i see that the pbx is send in the alert PI=2, the pbx is not capable from supplying the ring-back tone, is there any configuration that can be done in the gateway for supplying the ring-back in this situation.

Thanks

Jun 6 22:36:36.021: ISDN BR2/0 Q931: TX -> SETUP pd = 8 callref = 0x06

Bearer Capability i = 0x8090A3

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0x89

Progress Ind i = 0x8183 - Origination address is non-ISDN

Calling Party Number i = 0x0081, '1015'

Plan:Unknown, Type:Unknown

Called Party Number i = 0x80, '7'

Plan:Unknown, Type:Unknown

Jun 6 22:36:36.149: ISDN BR2/0 Q931: RX <- CALL_PROC pd = 8 callref = 0x86

Channel ID i = 0x89

Jun 6 22:36:36.382: ISDN BR2/0 Q931: RX <- ALERTING pd = 8 callref = 0x86

Progress Ind i = 0x8582 - Destination address is non-ISDN

Jun 6 22:36:42.740: ISDN BR2/0 Q931: TX -> DISCONNECT pd = 8 callref = 0x06

Cause i = 0x8290 - Normal call clearing

Jun 6 22:36:42.876: ISDN BR2/0 Q931: RX <- RELEASE pd = 8 callref = 0x86

Cause i = 0x8190 - Normal call clearing

Jun 6 22:36:42.884: ISDN BR2/0 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x06

1 REPLY
New Member

Re: no ring-back

try putting this in your dial-peer

progress_ind connect enable 2

259
Views
0
Helpful
1
Replies
CreatePlease login to create content