Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Please help me about OOS of standby PGW

Hi experts,

I 'm installing 2 PGW 9.2.2 on 2 sunfire v120 (one disk on one sun). So I follow the guides on Cisco Install guide document.

The procedure I do as:

1 - Install Sun solaris 8

2 - Install Patch CSCOh015

3 - Install MGC software 9.2.2

4 - Install Patch CSCOh013

I configured the parameters on XECfgParm.dat as the guides of Cisco for redundant system.

2 PGW status is : active and OOS (Out Of Service). If a PGW run first, it will get Active. If I stop MGC in Active PGW,and after restart it will be on OOS, the other will be in active automatically.

2 PGW connected to SW 3500 Cisco via every eri0 of them.

I configured PGWs like: speed 100 and mode link: fullduplex

I check platform.log file on them. They showed that LinkA is not communicated.

I look forward to your helps and thanking for that

Best regards,

2 REPLIES
Silver

Re: Please help me about OOS of standby PGW

Check whether pom.sync is disabled.

New Member

Re: Please help me about OOS of standby PGW

Thanks A-vazquez, pom.sync on both PGW was set with true, is there any advise else ?

137
Views
0
Helpful
2
Replies
CreatePlease login to create content