I've been struggling with this for a couple weeks now and hope that someone can give me a definitive answer, or at least lead me to one. I'm new to Cisco and video conferencing, so this is a bit of a learning experience for me.
I need to allow a newly installed Polycom HDX 7000 to work properly behind a ASA 5510 running ASA version 7.0(8). I've been running into intermittent issues like video dropping, but audio staying in a call; no ability for multipoint calls; and ghosting while in a call.
I've attached the results from "show config".
The internal IP of the Polycom unit is 192.168.0.225. It's using the following fixed ports: TCP: 3230 - 3243; UDP: 3230 - 3285
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...