Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PRI specification at Argentina

Hello,

We have a remote office at Argentina and we plan to migrate this office's voice system to our centralized IPT.  The Callmanager cluster is in New York.

Are there any concerns with call setup and tear down over the WAN, consider that the round trip response time could be over 100ms or around 200ms.

What is the PRI specifications in Argentia? Anyone has similar experiences? Any input or feedback will be appreciated.

Thanks

Mark

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Gold

PRI specification at Argentina

Until recently, Argentina did not have ISDN PRI, but only E1 R2, So check again with telco.

In any case the best setup is a local CME, not phones and CM in diffrent continents.

New Member

Re: PRI specification at Argentina

Hello,

Regarding PSTN connection ask their telco. In case when UCM doesn't support that signalling (R2) you can handle it on the gateway and configure H.323 or SIP trunk to UCM.

Packets delay is not very important, you should just check that jiter doesn't exceed dejitter buffer size on your devices. In practice I operate several sites with satellite connection and rtt over 800 ms without any problems.

Regards, Maxim

2 REPLIES
Hall of Fame Super Gold

PRI specification at Argentina

Until recently, Argentina did not have ISDN PRI, but only E1 R2, So check again with telco.

In any case the best setup is a local CME, not phones and CM in diffrent continents.

New Member

Re: PRI specification at Argentina

Hello,

Regarding PSTN connection ask their telco. In case when UCM doesn't support that signalling (R2) you can handle it on the gateway and configure H.323 or SIP trunk to UCM.

Packets delay is not very important, you should just check that jiter doesn't exceed dejitter buffer size on your devices. In practice I operate several sites with satellite connection and rtt over 800 ms without any problems.

Regards, Maxim

580
Views
0
Helpful
2
Replies
CreatePlease login to create content