I have two 6509's in location A. Mulitcasting is enabled on one of the 6509's. I am running pim spare mode and the rp is the above 6509. The multicasting application is IPTV.
The above 6509 has a gigabit layer 3 connectivity to our other location 25 miles away. All the channels work fine at the other location expect for one. What i mean is this one channel has bad reception at the remote location. Now its not the input as it plays at headquaters very well. Also if i rebuild the iptv group meaning it gets a new multicat ip address the problem moves to another channel. There is also no overlap in multicast mac address.
A similar problem had occured with the quality of reception at the remote location being poor. There could be many reasons for this like the port channel or the IOS or CatOS running on the Cat6k. This was solved by upgrading the supervisor engine software release to version 5.5(6) and the software on MSFC was upgarded to version 12.1.5b.E7.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...