Problem with unicast videostream using ISDN BRI between 2 876 routers
I have two 876 routers with the proper IOS. I configured the ISDN line. It's working fine. Pinging and telnetting vice versa.
On one end there is a videocamera with the encoder (Bosch) connected to the Vlan-side of one router. On the other side of the ISDN line there is a decoder (with monitor) connected to the VLAN side of the outher router.
The encoder is configured to send a videostream to the (ip-address) of the decoder, unicast and 64Kb.
The problem is that the decoder doesn't seem to pickup the MPEG4 video-stream I
t does see the video stream( it shows a jpeg-snapshot which refreshes after several seconds).
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...