Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problems with FXS disconnect

Hi,

I have 186x series router with build-in four FXS ports. When I call FXS port (SCCP IP Phone through H.323), I get connected to GSM GW; when I disconnect by IPPhone the line is still busy

Config:

!

voice-port 0/0/3

no supervisory disconnect lcfo

no battery-reversal

signal groundStart

input gain 6

compand-type a-law

no comfort-noise

cptone PL

!

!

dial-peer voice 600 pots

max-conn 1

destination-pattern 0048.........

port 0/0/3

forward-digits all

!

Ani ideas how to say to GSM GW that call is cleared?

Best Regards

4 REPLIES
Hall of Fame Super Gold

Re: Problems with FXS disconnect

To begin with, should be signal loopstart.

Then check GSM box documentation for what disconnect supervision method it can use.

Note these connection are better done with ISDN BRI or SIP. Analog is always source of trouble.

New Member

Re: Problems with FXS disconnect

I tried loopstart earlier and the problem still exists

It's a Nokia GSM adapter - the default rule for disconnect supervision in this adapter is monotoring silence. Any idea how to apply such settings on Cisco router ?

Best Regards

Hall of Fame Super Gold

Re: Problems with FXS disconnect

Silence is silence, no special config is required.

I have a client with old Nokia adapters and they work acceptably. They are of the type with both FXS and FXO ports.

New Member

Re: Problems with FXS disconnect

It is old Nokia adapter - can You paste part of config ? (I'm interested in voice-port part) Thanks

1411
Views
0
Helpful
4
Replies